Matek ELRS-R24-P6 ExpressLRS 2.4G PWM Receiver With Antenna Support 2~8S VBat Voltage Sense

  • $15.00



Matek ELRS-R24-P6 ExpressLRS 2.4G PWM Receiver With Antenna Support 2~8S VBat Voltage Sense

Description:

  • Brand: Matek Systems
  • Model: ELRS-R24-P6
  • Item: PWM Receiver
  • ESP8285, SX1281
  • Antenna connector: IPEX MHF 1
  • 6x PWM outputs
  • Support 2~8S VBat voltage sense
  • RF Frequency: 2.4GHz (2400~2480MHz)
  • Telemetry power: 12dbm
  • Receiver output protocol: PWM
  • Input voltage: 4~9V DC @ “+” pad
  • Voltage sense: 34V Max. @ “VBat” pad
  • Power dissipation:  45mA(binding), 85mA(wifi mode)
  • PCB size: 20mm x 18mm
  • Weight: 2g w/ antenna

 

Firmwares

  • ExpressLRS 3.0 or newer, DIY 2.4GHz / DIY 2400 RX PWMP EX.
  • ExpressLRS wiki for PWM receiver, Click HERE
  • Make sure Receiver and TX module both are running ExpressLRS 3.0 or newer.

——————————————————-

* Receiver has ExpressLRS 3.0 preloaded with binding phrase '123456',  the Receiver will never enter binding mode if using the traditional binding procedure.

* You need to reflash it with your binding phrase OR go into WebUI to set your binding phrase.


Flashing via Wifi

  • Disconnect ESC and servos from receiver first.
  • Power on receiver by 5V source. Receiver's LED(Red) will blink slow at first, and after 20s, it should blink fast indicating it's on Wifi Hotspot Mode.
  • More detailed steps,  pls refer this page.
  • Target: DIY 2.4 GHz / DIY 2400 RX PWMP EX.


Flashing via UART

  • Disconnect ESC and servos from receiver first.
  • Wire the receiver into the USB-TTL adapter, with TX on receiver connected to the Rx on the USB-TTL, and RX on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to 5V and GND of the Receiver.
  • Press the boot button while powering on the receiver, then release – the Red LED on receiver should now be solid.
  • Select the target DIY 2.4 GHz / DIY 2400 RX PWMP EX  and  “UART” for Flashing Method,  set your bind phrase and Firmware Options and once done, click on Build and Flash.


Package Included:

  • 1x Matek Systems ELRS-R24-P6 Receiver
  • 1x IPEX MHF1 Antennas. 15cm
  • Dupont 2.54 pins  (Board is shipped unsoldered)